OLIGHT M2R Pro Warrior Manual

IN THE BOX

M2R Pro Warrior (with Battery)

Holster

USB Magnetic Charging Cable

Lanyard

• Do not throw the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
• Do not cover the light head when the flashlight is on, or place the flashlight head on the ground. The radiation energy of the flashlight may cause damage to the flashlight itself, or even result in burning to flammable objects.

• Do not activate turbo mode repeatedly under high temperature to prevent the flashlight body from overheating and hurting the user's hand.
• The tail switch may not work while immersed in sea water or other conductive media. Please try to keep it clean and dry.
• Do not use Non-protected rechargeable batteries.
• If the product is left unused or carried and transported, please lock the button to avoid accidentally activating the flashlight.

NOTICE:

• When the flashlight is turned off, moonlight, low, med1, med2, or high mode will be memorized and become the default mode when the light is turned on again (high mode will only be memorized for 10 minutes. After that, the memorized mode will revert to the med1 setting).
• The flashlight has a standby current below 40µA. If the flashlight is to be put away for a long time, please loosen the tail cap by unscrewing it to cut off the current circuit and charge it before use again.
• The turbo mode will slowly step down to high mode in 4.5 minutes in normal temperature.
• Do not short circuit the switch cap with the ring outside it for a prolonged period. The short circuit in this case will result in a loss of current below 6mA, and may lead to a complete battery drain if it is in this state for too long.

HOW TO OPERATE

SIDE SWITCH

ON/OFF: Single click the side switch to turn the light ON/OFF. When the light is turned on again, it will return to the previously memorized mode.

CHANGE BRIGHTNESS LEVEL: When the flashlight is on, press and hold the side switch and it will, starting from the present brightness level, automatically cycle through low, med2, med1, and high mode. The mode is selected when the side switch has been released. ( Please note: moonlight and turbo are not in the automatic cycle ).

MOONLIGHT MODE: When the flashlight is off, press and hold the side switch for over one second to access the moonlight mode. If the memorized mode is moonlight, simply click the switch to access it.

TURBO AND RETURN: fast double click on side switch to enter into Turbo, double click again to return. If memory mode were High or Med 1, the output is Med 1; if memory mode were Med 2、low or Moonlight, the output is memory mode.

STROBE: Quickly triple click the side switch to enter the strobe mode. To quit this mode, single click or press and hold the side switch.

LOCKOUT/UNLOCK: When the flashlight is off, press and hold the side switch ( for about 2 seconds ) to access the button lockout mode ( the flashlight will enter the moonlight mode first and will then switch off to signal the lockout mode ). Under the lockout mode, press and hold the side switch for less than one second. The red indicator below the side switch will be on for two seconds to signal that the light is still in lockout mode. To unlock it, keep holding the side switch for over one second until the moonlight mode is on again.

TAIL SWITCH

The M2R Pro produces different output settings by pressing lightly or hard on the tail switch (please refer to the following program configurations).

TWO DIFFERENT PROGRAM CONFIGURATIONS

CONFIGURATION 1 (FACTORY DEFAULT SETTING): Half press for Med 1, hard press for Turbo;

SPECIFICATIONS

	TURBO	HIGH	MED1	MED2	LOW	MOON
	300m	185m	110m	55m	27m

1.5m	22,400cd	IPX8

(L)5.37* (D)1.16in (L)136.5 *(D)29.5mm	6.31oz / 179g (Including Battery)

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.

Within 5 years of purchase: Contact Olight for repair or replacement.

Battery warranty: Olight offers a one year warranty for all rechargeable batteries.

MCC magnetic USB charging cable: 1 year

The other no warranty fragile or low-value fittings like lanyard and clip, you can contact post-sale in 30 days after purchase if it has quality drawback or damage under normal use condition. Over 30 days or damage under abnormal use condition, the conditional quality assurance will be provided as appropriate.

EU-DECLARATION OF CONFORMITY

EU-Declaration of Conformity can be found here CE: https://olightworld.com/ec-declaration

USA Customer Support
cs@olightstore.com

Global Customer Support
Customer-service@olightworld.com

Visit www.olightworld.com to see our complete product line of portable illumination tools.

Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6
Zhongnan Road, Changan Town, Dongguan City,
Guangdong, China.
Made in China