OLIGHT S2A BATON - 550 Lumens Flashlight Manual

Table of Contents

Contents

1 INSIDE THE BOX
2 SPECIFICATIONS
3 BATTERY INSTALLATION
4 AVAILABLE BATTERIES
5 HOW TO OPERATE
6 NOTICE
7 WARRANTY
8 Documents / Resources
- 8.1 References
- 8.2 Download manual

INSIDE THE BOX

S2A Baton, 2 x AA Lithium batteries (installed inside the flashlight), Lanyard, User manual

SPECIFICATIONS

Material: 6061-T6 aluminum alloy structure, Type III hard anodizing, stainless steel pocket clip.

SPECIFICATIONS

BATTERY INSTALLATION

Ensure batteries are inserted with the negative (-) end pointing to the tailcap. The flashlight will not operate with incorrectly inserted batteries.
BATTERY INSTALLATION

warning Before first use, unscrew the tailcap and take off the insulating film.

AVAILABLE BATTERIES

2 x AA Lithium Batteries
2 x AA Alkaline or NiMH Batteries

HOW TO OPERATE

ON/OFF: To turn on the light, single-click the side switch, the flashlight outputs at memorized brightness level, single-click again will turn the light off.

CHANGE BRIGHTNESS LEVEL: Press and hold the side switch when the light is on. The output will cycle through low – medium – high – turbo mode. Release the side switch when the desired brightness level is achieved.

MOONLIGHT: From off state, press then hold the side switch for 1 second enables the moonlight mode.

DIRECT ACCESS TO TURBO: From off state, double clicks directly activate turbo mode.

STROBE: Triple-click the side switch to activate strobe mode, any other operation will quit the strobe.

TIMER: The light contains two timer settings: long timer (9minutes) and short timer (3 minutes). Double click the side switch to enter this setting. Output blinks once means 3 minutes short timer, blinks twice means 9 minutes long timer. Double click the side switch to change the timer to the opposite setting. The light will automatically shut off when the timer is overflow.

NOTICE

One of the five following output modes: moonlight, low, medium, high and turbo, will be memorized after the light turns off. (The flashlight will only memorize high and turbo mode for 10 minutes after the light is turned off, the memory turns to medium mode)
Moonlight mode is not among of normal dimming sequence (low - medium - high - turbo), from moonlight mode, press then hold the side switch to enter into normal dimming sequence.
In the beginning of Turbo mode, the output will be in maximum for 3 minutes, within following 1 minute, output ramps down to 60% of the initial output.
When the strobe mode on, press and hold the side switch and the light will quit strobe mode, and it will then return to the memorized mode.
Except the black one, all other colored ones are fluorescent.

Do not throw the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
Do not mix fresh and old batteries, different battery brands or chemistry types.

Do not keep activating the turbo mode when the environmental temperature is high in case the flashlight body gets too hot to hold.
When installing the battery, ensure that the two positive polarity (+) ends are pointing towards the head of flashlight (LED side).
If the flashlight is going to be transported or carried for long journey, please gently unscrew the tail cap in advance to cut off the electricity circuit to avoid accident activation.
For long-term storage, please remove the batteries from the light to avoid battery leakage.