Fujitsu ApeosPrint C4030 Reference Manual page 177


Determination method example
If [Auto Layout] = ON, [Original Size] = [Auto Detect], [Zoom Mode] = [Paper Size], [Area Determine
Mode] = [IP] and [Paper Margin] = 10 mm, and [Pen Attributes] of [Pen Width] = 0.1 mm
Note
There is no character size specification command, and area specified by [IP] and [IW] is A3.

 Determination method
1.
Areas "-8399, -5938, 8399, 5938" specified by IP commands are the object areas.
2.
There is no character size specification command, and the pen width is 0.1 mm, so half of the A3
size default character size height (75 plotter unit) is added to the object area.
Object area at this point: -8074, -6013.8474, 6013
3.
Paper margin (10 mm) is removed from the object area.
Object area at this point: -8474, -5613.8074, 5613
4.
Since the drawn object area (printed area) is greater than A4 and equal to or smaller than A3, the
document size is A3.
How to determine the paper size

If [Original Size] is [Auto Detect] and [Paper Supply] is [Auto Select]
 If [Zoom Mode] is [Paper Size] and the same size paper as the document size is loaded in the tray,
the paper size is the same as the document size.
 If [Zoom Mode] is [Coordinate Area], the paper size is the object area determined in the area
determination mode.
Note
 If the same paper size is not available, the following size is selected.
- Exceeding the maximum size: Maximum size
- Under the minimum size: Minimum size
- Between the minimum and maximum sizes: Fitting size
How to determine the reduction rate
 If [Original Size] is [Auto Detect] and [Zoom Mode] is [Paper Size]
Reduction rate is determined by the drawn object area and [Paper Size]. Hard Clip area is [Paper].
 If Auto Layout is [Auto Layout], the document is placed at the center of the paper.
 If the starting point is the bottom left or center, the starting points of the document and paper are
aligned.
 If the reduction rate is less than 22.5% (such as A0 -> A5), it will be the actual size.
IN;
IP-8399,-5938,8399,5938;
IW-8399,-5938,8399,5938;
PU;
SP1;
:
:
SP0;
177
10.2 Emulation