System Control Block; Summary Of System Control Block Functions; Pin Description; Table 11: Pin Summary - Philips LPC2194 User Manual

Philips Semiconductors
ARM-based Microcontroller

4. SYSTEM CONTROL BLOCK

SUMMARY OF SYSTEM CONTROL BLOCK FUNCTIONS

The System Control Block includes several system features and control registers for a number of functions that are not related
to specific peripheral devices. These include:
• Crystal Oscillator.
• External Interrupt Inputs.
• Memory Mapping Control.
• PLL.
• Power Control.
• Reset.
• VPB Divider.
• Wakeup Timer.
Each type of function has its own register(s) if any are required and unneeded bits are defined as reserved in order to allow future
expansion. Unrelated functions never share the same register addresses.

PIN DESCRIPTION

Table 11 shows pins that are associated with System Control block functions.

Table 11: Pin summary

Pin name Pin direction
X1 Input
X2 Output
EINT0 Input
EINT1 Input
EINT2 Input
EINT3 Input
RESET Input
System Control Block
Crystal Oscillator Input- Input to the oscillator and internal clock generator circuits.
Crystal Oscillator Output- Output from the oscillator amplifier.
External Interrupt Input 0- An active low general purpose interrupt input. This pin may be
used to wake up the processor from Idle or Power down modes.
Pins P0.1 and P0.16 can be selected to perform EINT0 function.
LOW level on this pin immediately after reset is considered as an external hardware
request to start the ISP command handler. More details on ISP and Flash memory can be
found in "Flash Memory System and Programming" chapter.
External Interrupt Input 1- See the EINT0 description above.
Pins P0.3 and P0.14 can be selected to perform EINT1 function.
External Interrupt Input 2- See the EINT0 description above.
Pins P0.7 and P0.15 can be selected to perform EINT2 function.
External Interrupt Input 3- See the EINT0 description above.
Pins P0.9, P0.20 and P0.30 can be selected to perform EINT3 function.
External Reset input- A low on this pin resets the chip, causing I/O ports and peripherals
to take on their default states, and the processor to begin execution at address 0.
64
LPC2119/2129/2194/2292/2294
Pin Description
Preliminary User Manual
May 03, 2004