Setup; Installing The Roller; Installing The Ball Studs - Toro 04654 Operator's Manual

Setup

Media and Additional Parts
Description
Ball stud
Operator's Manual

Installing the Roller

The cutting unit is shipped without a front roller.
Obtain a roller from your authorized Toro distributor
and install it on the cutting unit, as follows:
1. Remove the plow bolt and flange locknut
securing one of the height-of-cut arms to the
cutting unit side plate
1. Height-of-cut arm
2. Adjusting screw
3. Plow bolt
2. Loosen the roller-mounting screws in the
height-of-cut arms
3. Slide the roller shaft into the height-of-cut arm
on the opposite end of the cutting unit
4. Slide the height-of-cut arm onto the roller shaft
(Figure 3).
5. Loosely secure the roller to the cutting unit with
the height-of-cut arm and fasteners previously
removed (Figure
6. Center the roller between the height-of-cut arms.
(Figure 3).
Figure 3
4. Flange locknut
5. Roller-mounting screw
(Figure 3).
(Figure
3).
Qty.
2 Mount this to the roller.
1 Read before installing and operating the cutting unit.
7. Tighten the roller-mounting screws
8. Adjust to the desired height-of-cut and tighten
the height-of-cut arm mounting fasteners.

Installing the Ball Studs

Install a ball stud on each end of the front roller
4).
1. Ball stud
g278288
3).
5
Use
(Figure
Figure 4
3).
(Figure
g279642