Setup; Installing The Front Roller; Repositioning The Counterweights - Toro 04479 Operator's Manual

Setup

1

Installing the Front Roller

No Parts Required
Procedure
The dethatching unit is shipped without a front roller.
Install the roller using the loose parts supplied with the
dethatching unit and Installation Instructions included
with the roller.
2
Repositioning the
Counterweights
No Parts Required
Procedure
The dethatching units are shipped with the
counterweight mounted to the right end and the motor
mount to the left end of the dethatching unit. To move
the counterweight to the other side of the dethatching
unit, do the following steps:
1. Remove the 2 capscrews that secure the
counterweight to the right end of the dethatching
unit.
2. Remove the counterweight (Figure 3).
4
Figure 3
1. Counterweight
3. Remove the 2 Allen-head screws that secure the
motor mount to the left end of the dethatching
unit.
4. Remove the motor mount
5. Apply grease to the inside diameter of the drive
spline (Figure 4).
Figure 4
1. Drive spline
2. Motor mount
6. On the right end of the dethatching unit, apply
a light coating of oil to the O-ring and install
the motor mount with the 2 Allen-head screws
previously removed.
Note:
Torque the screws to 16 to 20 N-m (12
to 15 ft-lb).
g016405
(Figure 4).
g016697
3. Allen-head screw