Setup; Installing The Roller; Adjusting The Cutting Unit - Toro 04651 Operator's Manual

Setup

Media and Additional Parts
Description
Operator's Manual
Parts Catalog (not included)—refer to the
included postcard for information on obtaining
the Parts Catalog
Note:
Determine the left and right sides of the
machine from the normal operating position.

Installing the Roller

The cutting unit is shipped without a front roller.
Obtain a roller from your authorized Toro distributor
and install it on the cutting unit, as follows:
1. Remove the plow bolt and flange locknut
securing one of the height-of-cut arms to the
cutting unit side plate
1. Height-of-cut arm
2. Adjusting screw
3. Plow bolt
2. Loosen the roller-mounting screws in the
height-of-cut arms
3. Slide the roller shaft into the height-of-cut arm
on the opposite end of the cutting unit
4. Slide the height-of-cut arm onto the roller shaft
(Figure 3).
(Figure 3).
Figure 3
4. Flange locknut
5. Roller-mounting screw
(Figure 3).
(Figure
Qty.
1
Review the material and save it in an appropriate place.
–
5. Loosely secure the roller to the cutting unit with
the height-of-cut arm and fasteners previously
removed
6. Center the roller between the height-of-cut arms.
7. Tighten the roller-mounting screws
8. Adjust to the desired height-of-cut and tighten
the height-of-cut arm mounting fasteners.

Adjusting the Cutting Unit

1. Support the cutting unit; refer to
Cutting Unit (page
2. Adjust the bedknife to the reel.
3. Adjust the rear roller height.
4. Adjust the height of cut.
5. Adjust the cut-off bar.
Refer to Adjusting the Cutting Unit (page 5)
for complete instructions for performing these
adjustments.
g292580
3).
5
Use
(Figure 3).
11).
(Figure 3).
Supporting the