Operating The Throttle; Operating The Ignition Switch - Toro 74312 Operator's Manual

•
Do not mow near drop-offs, ditches, or
embankments. The machine could suddenly roll
over if a wheel goes over the edge or if the edge
gives way.
•
Stop the blades whenever you are not mowing.
•
Stop the machine and inspect the blades after
striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
•
Disengage the drive to the cutting unit and shut
off the engine before adjusting the height of
cut (unless you can adjust it from the operating
position).
•
Never run an engine in an area where exhaust
gases are enclosed.
•
Never leave a running machine unattended.
•
Before leaving the operating position (including
to empty the catchers or to unclog the chute), do
the following:
– Stop the machine on level ground.
– Disengage the power take-off and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key.
– Wait for all moving parts to stop.
•
Do not operate the machine when there is the risk
of lightning.
•
Do not use the machine as a towing vehicle.
•
Do not change the governor speed or overspeed
the engine.
•
Use accessories and attachments approved by
Toro only.
Slope Safety
•
Slow down the machine and use extra care on
hillsides. Travel up and down on hillsides. Turf
conditions can affect the stability of the machine.
•
Avoid turning the machine on slopes. If you must
turn the machine, turn it slowly and gradually
downhill, if possible.
•
Do not turn the machine sharply. Use care when
reversing the machine.
•
Use extra care while operating the machine with
attachments; they can affect the stability of the
machine.
•
A 2-post ROPS (Rollover Protection System) is
available for the machine as an accessory. A
ROPS is recommended if you will be mowing next
to drop-offs, near water, or on steep banks which
could result in a rollover. Contact an Authorized
Service Dealer for more details. The California
Code of Regulations requires ROPS (if available)
on all mowers used commercially effective March
1, 2011.

Operating the Throttle

You can move the throttle control between the F
and S positions
LOW
Always use the middle position when turning on the
mower deck and blower with the PTO-engagement
lever.
Operating the Ignition
Switch
1. Turn the ignition key to the S
(Figure 16).
Note:
When the engine starts, release the key.
Important:
Do not engage the starter for
more than 5 seconds at a time. If the engine
fails to start, wait 15 seconds between
attempts. Failure to follow these instructions
can burn out the starter motor.
Note:
You may need multiple attempts to start
the engine when you start it the first time after
the fuel system has been without fuel completely.
2. Turn the ignition key to the S
off the engine.
21
(Figure 15).
G008946
Figure 15
position
TART
G008947
Figure 16
position to shut
TOP
AST
g008946
g008947