Storage; Cleaning And Storage - Toro 74947 Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power takeoff (blade-control
switch (PTO), engage the parking brake, and
turn the ignition key to the
the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine and hydraulic system. Clean dirt and
chaff from the outside of the engine cylinder
head fins and blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
control panel, engine, hydraulic pumps, and
motors.
3. Check the brake; refer to
Brake (page 54).
4. Service the air cleaner; refer to
Cleaner (page 39).
5. Grease the machine; refer to
36).
6. Change the crankcase oil; refer to
Engine Oil (page
7. Check the tire pressure; refer to
Tire Pressure (page
8. Change the hydraulic filters; refer to
the Hydraulic Fluid and Filters (page
9. Charge the battery; refer to
(page 47).
10. Scrape any heavy buildup of grass and dirt
from the underside of the mower, then wash the
mower with a garden hose.
Note:
Run the machine with the blade-control
switch (PTO) engaged and the engine at high
idle for 2 to 5 minutes after washing.
11. Check the condition of the blades; refer to
Servicing the Cutting Blades (page
12. Prepare the machine for storage when non-use
occurs over 30 days. Prepare the machine for
storage as follows:
A. Add a petroleum based
stabilizer/conditioner to fuel in the
tank. Follow mixing instructions from
the stabilizer manufacturer. Do not use
an alcohol-based stabilizer (ethanol or
methanol).
position. Remove
OFF
Adjusting the Parking
Servicing the Air
Lubrication (page
Changing the
41).
Checking the
49).
Replacing
61).
Charging the Battery
65).
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh fuel and
used at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Shut off the engine, allow it to cool, and
drain the fuel tank; refer to
Fuel Tank (page 45)
Section.
D. Start the engine and run it until it stops.
E. Dispose of fuel properly. Recycle according
to local codes.
Important:
stabilizer/conditioned fuel over
90 days.
13. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or
storage area.
16. Remove the key from the ignition switch
and keep it out of reach of children or other
unauthorized users.
17. Cover the machine to protect it and keep it clean.
70
Servicing the
in the Maintenance
Do not store