Servicing The Cutting Blades - Toro 74947 Operator's Manual

Servicing the Cutting
Blades
To ensure a superior quality of cut, keep the blades
sharp. For convenient sharpening and replacement,
you may want to keep extra blades on hand.
Blade Safety
A worn or damaged blade can break, and a piece of
the blade could be thrown toward you or bystanders,
resulting in serious personal injury or death. Trying to
repair a damaged blade may result in discontinued
safety certification of the product.
•
Inspect the blades periodically for wear or damage.
•
Use care when checking the blades. Wrap the
blades or wear gloves, and use caution when
servicing the blades. Only replace or sharpen the
blades; never straighten or weld them.
•
On multi-bladed machines, take care as rotating 1
blade can cause other blades to rotate.
Before Inspecting or Servicing the
Blades
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and engage the
parking brake.
2. Shut off the engine, remove the key, and
disconnect the spark-plug wires from the spark
plugs.
Inspecting the Blades
Service Interval: Before each use or daily
1. Inspect the cutting edges
2. If the edges are not sharp or have nicks, remove
and sharpen the blade; refer to
Blades (page 66).
3. Inspect the blades, especially in the curved area.
4. If you notice any cracks, wear, or a slot forming
in this area, immediately install a new blade
(Figure 95).
(Figure 95).
Sharpening the
1. Cutting edge
2. Curved area
65
Figure 95
3. Wear/slot forming
4. Crack
g006530