Toro 74947 Operator's Manual page 37

Figure 41
5. For machines with 72-inch decks only, grease
the 3 spindle bearings until grease comes out
the lower seals (Figure
Figure 42
6. Grease the drive belt idler arm
g185957
42).
g009029
(Figure 42).
7. Remove the dust cap and adjust the caster
pivots.
Note:
Keep the dust cap off until greasing is
complete. Refer to
Bearing (page
8. Remove the hex plug.
9. Thread a grease fitting into the hole.
10. Pump grease into the fitting until it oozes out
around the top bearing.
11. Remove the grease fitting in the hole.
12. Install the hex plug and dust cap
13. Grease the caster-wheel bearings
37
Figure 43
Adjusting the Caster-Pivot
50).
(Figure
Figure 44
(Figure
g009030
44).
g009187
44).