Cleaning; Cleaning Under The Mower; Disposing Of Waste - Toro 74947 Operator's Manual

Figure 103
1. Bolt
2. Spacer
3. Locknut
4. Spring
2. Remove damaged or worn grass deflector.
3. Place spacer and spring onto the grass deflector.
Place a J-end of spring behind deck edge.
Note:
Ensure that a J-end of spring is installed
behind deck edge before installing the bolt as
shown in Figure 103.
4. Install the bolt and nut.
5. Place a J-hook end of spring around grass
deflector (Figure 103).
Important:
The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the
full down position.
g015594
5. Spring installed
6. Grass deflector
7. J-hook end of spring

Cleaning

Cleaning under the Mower

Service Interval: Before each use or daily
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the N
position, and set the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the mower to the transport position.

Disposing of Waste

Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants to the environment. Dispose of
these according to your state and local regulations.
69
-L
EUTRAL OCK