Safety Instructions During Transport; Safety Instructions During Installation; Safety Instructions During Cleaning Or Maintenance; Safety Instructions During The Use - ABB 2 Series Operation And Installation Manual

Safety
2.5.1

Safety instructions during transport

• Make sure that the hoisting equipment or forklift truck can lift the EVSE
safely.
• Take into account the mass and the center of gravity of the EVSE.
• Obey the applicable safety instructions for the hoisting equipment or for the
forklift truck. For example, the instructions specified on the related shipment
label that is applied to the EVSE packaging.
• Put on the correct personal protective equipment.
2.5.2

Safety instructions during installation

• Make sure that there aren't any supply voltages on the input cables during the
complete installation procedure.
• Keep unqualified personnel at a safe distance during installation.
• Only use electrical wires of sufficient gauge and insulation to handle the
rated current and voltage demand.
• Make sure that the load capacity of the grid is in accordance with the EVSE.
• Make sure that the wiring inside the EVSE is protected from damage and
cannot get trapped when you open or close the EVSE.
• Do not open any covers/doors of the equipment in case of adverse climatic
conditions. Infiltration of water or sand and presence of high humidity can
cause damage of the equipment. It is of paramount importance to evaluate
the weather conditions in the risk assessment prior any intervention on the
equipment.
• Protect the EVSE with safety devices and measures that the local rules
specify.
• Make sure that the EVSE is connected to a Protective Earth (PE).
• Make sure that the connections to the EVSE comply with all applicable local
rules.
• Put on the correct personal protective equipment.
Additional instructions during ground works
• Make sure that the equipments used during ground works are certified.
• Comply with all applicable local rules.
2.5.3

Safety instructions during cleaning or maintenance

• Make sure that there are any supply voltages on the input cables during the
complete cleaning or maintenance procedure.
• Keep unauthorized personnel at a safe distance during cleaning or
maintenance.
• If for cleaning or maintenance it is necessary to remove safety devices,
immediately install the safety devices after the work.
• Put on the correct personal protective equipment.

2.5.4 Safety instructions during the use

Do not use the EVSE and immediately get in contact with the manufacturer if the safety or the
safe use of the EVSE is at risk. This includes, but is not limited to, these conditions:
• An enclosure has damage.
• An EV charge cable or connector has damage.
• Lightning struck the EVSE.
• There was an accident or a fire at or near the EVSE.
• Water entered the EVSE
13