Table of Contents
Advertisement
Removing the Cover Plate
1. Lower the grinder, stop the engine, and remove the key.
WARNING
There is a belt under the cover that is moving
when the machine is running and can catch
fingers, hands, loose hair, and clothing,
causing serious injury, amputation, or death.
Always stop the engine and wait for all moving
parts to stop before removing the cover.
2. Loosen the bolt at the rear of the cover plate.
3. Loosen the 3 bolts securing the cover plate to the
frame sequentially until the cover is free (Figure 26).
Figure 26
1. Cover plate
4. Pull up on the rear of the cover plate until it clears the
engine and then pull it off of the machine.
Installing the Cover Plate
1. Lower the grinder, stop the engine, and remove the key.
2. Slide the cover plate into place and secure it with the 3
bolts you loosened previously (Figure 26).
Removing the Bottom Shield
1. Lower the grinder, stop the engine, and remove the key.
2. Loosen the 2 bolts securing the bottom shield
sequentially until the shield is free (Figure 27).
2. Bolts
1. Bottom shield
3. Pull the shield back and out of the machine.
Installing the Bottom Shield
1. Lower the grinder, stop the engine, and remove the key.
2. Slide the bottom shield into the machine so that it rests
on all 4 tabs (Figure 27).
Note: You may need to lift up on the bottom shield to
ensure that it rests on the front tabs.
3. Secure the shield with the bolts you loosened
previously.
22
Figure 27
2. Bolts
Advertisement
Table of Contents
