5.
Connect the throttle cable to engine.
6.
Use the previously-removed bolts to secure the
new coupler guard to the transmission cover.
4
Lubricating and Adjusting
the Machine
No Parts Required
Procedure
1.
Lubricate the machine according to the
instructions in your Operator's Manual.
2.
Fill the engine crankcase with oil; refer to
Servicing the Engine Oil (page
3.
Adjust the engine speed to the following
specifications:
High idle (no load)
Low idle (no load)
9).
3450 ± 100 rpm
1900 ± 100 rpm
Product Overview
1. Choke lever
2. Fuel-shutoff valve
Controls
Choke Control
The choke control is located on the side of the engine
(Figure
4); you use it to help start a cold engine
Note:
Do not start or run a warm engine with the
choke in the CLOSED position.
•
Move the choke lever all the way to the left
(away from starter handle) to set the choke to the
CLOSED position.
•
Move the choke lever all the way to the right
(toward starter handle) to set the choke to the
OPEN position.
Fuel-Shutoff Valve
The fuel-shutoff valve is located on the side of the
engine below the choke control
Note:
Close the fuel-shutoff valve when the machine
is not used for a few days, during transport to and
from the job site, or when the machine is parked
inside a building; refer to
Fuel-Shutoff Valve (page
5
Figure 4
3. Recoil starter handle
(Figure
4).
Opening and Closing the
7).
g265059