Toro 139-5637 Instructions Manual page 10

1. Shut off the engine and wait for all moving
parts to stop; refer to
Maintenance (page
2. Position the machine so that the engine is level,
and clean the area around the oil-fill tube
10).
Figure 10
1. Dipstick
3. Remove the dipstick by rotating it
counterclockwise.
4. Remove the dipstick and wipe the end clean.
5. Insert the dipstick fully into the oil-fill tube, but
do not thread it in.
6. Remove the dipstick and check the engine-oil
level (Figure 11).
Preparing the Machine for
8).
(Figure
2. Drain plug and washer
1. Filler tube
g266053 2. Dipstick
3. Upper limit
7. If the engine-oil level is incorrect, add or drain oil
to correct the level; refer to
Oil (page
Changing the Engine Oil
Service Interval: After the first 20 hours
Every 100 hours
WARNING
Oil may be hot after the engine has been run,
and contact with hot oil can cause severe
personal injury.
Avoid contacting the hot engine oil when you
drain it.
1. Shut off the engine and wait for all moving
parts to stop; refer to
Maintenance (page
2. Raise the engine off the ground and place a pan
under the drain plug to catch the oil.
3. Remove the drain plug
4. When the oil has drained completely, lower the
engine to the ground, replace the drain plug and
washer, and torque the plug to 18 N⋅m (13 ft-lb).
Note:
Dispose of the used oil at a certified
recycling center.
5. Remove the dipstick, and slowly pour oil into the
oil-fill hole until the oil is at the correct level.
10
Figure 11
4. Lower limit
5. Drain plug
Changing the Engine
10).
Preparing the Machine for
8).
(Figure 10).
g019686