Advertisement
QUICK START GUIDE
Install Gateway Assembly-R steps
Step R3 - Connect Ethernet Cable (LAN)
1. Connect Ethernet Cable (LAN) to Gateway Assembly J5 - see Wiring Diagram.
2. Replace the protective cover of the Gateway kit ( rear panel only) - four screws.
Step R4 - Configure Gateway Card - per site engineering instructions
1. Connect a laptop or PC to the RS-232 port of the Gateway assembly (see
Wiring Diagram).
2. If not already installed, download and install EasyView2 (see Reference
Documents).
3. Start Easyview2.
4. Login as administrator - Password: administrator
5. Configure the IPV4 or IPV6 settings on the Settings
screen.
6. Configure password under Settings
Go to Step V1 if installing a VIM1EC Meter.
Go to Step V3 if connecting to an existing VIM1EC Meter.
Install VIM1EC Meter-V Steps
Step V1 - Record Configuration of Existing VIM1 Meter
See Information VIM1EC Meter for Meter Parameters table and Menu Map.
Number Of Loads (Item 5)
Meter Type (Item 6) Load ID Format (Item 7)
First Load Location (Item 8)
Shunt Rating (Item 9)
Local Buzzer (Item 2)
Load Available (Item 12)
Power Loss (Item 13)
Overload Delay (Item 16)
Assigned Circuit (Item 17)
Other parameters as instructed in Site Engineering Instructions.
Page 4
© 2023 ABB. All rights reserved.
(continue)
Network Settings
Passwords.
BDFB Gateway_QSG
Screws
Rev. 2.0
Advertisement
