Table of Contents
Advertisement
g
EV Charging Station
2. Install the SW
It is strongly recommended to install the SW in the default location.
-
Insert CD 1 of the EV100 Application into the CD ROM and launch setup.exe
-
Follow instructions and keep default Port settings of 3306
-
Once finished with CD 1, insert CD 2 of the EV100 Application and launch setup.exe
-
Follow instructions and keep default port settings at 9500 (unless another port has been set up in
the individual EVSE stations on the configuration server page)
-
Add optional field descriptions for user identification, such as phone number, e-mail address, etc.
which shall be stored alongside the RFID identifier.
4.4.4 Setup Validation
After the successful installation of the EVSE network and EV100 Software, validate the installation by
following these steps:
1. Check that the EV100 Listener Service is running
GE EV Charging Station User Manual
- Driver Attributes Menu -
- User Attributes Menu -
User Manual & Installation Instructions
Figure 75
- Software Driver Menu -
- Software User Menu -
80 of 86
Advertisement
Table of Contents
