Advertisement
•
Tighten the cap screw to increase the speed.
•
Loosen the cap screw to decrease the speed.
3.
Tighten the jam nuts to secure the socket-head
cap screws.
4.
Repeat steps
1
through
Adjusting the Full-speed Tracking
If you need to adjust the full-speed tracking, refer to
the machine Operator's Manual.
8
Installing the Stop Plates
No Parts Required
Procedure
Install the stop plates in the exact previous locations,
and secure them with the existing bolts
3
as necessary.
(Figure
7).
Operation
Using the Speed Limiter Kit
If you lower the attachment while driving over a certain
speed, the cam does not limit the driving speed until
you manually decrease the speed by moving the
control handles accordingly.
If you raise the attachment while driving at the full
cam-limited speed, the machine might not move at the
regular full speed until you take some pressure off the
control handles. To do so, simply back the handles
slightly away from the full-forward position.
Disabling the Speed Limiter
Kit
1.
Using a twisting motion, pull the springs off the
bolts
(Figure
18).
1. Slot
2.
Latch the hook on the end of each spring into
the slot in the appropriate lift bracket.
When you want to use the speed limiter kit again,
install the springs on the bolts in the reverse manner
in which you removed them.
8
Figure 18
2. Spring
g024707
Advertisement
