Advertisement
Figure 6
1. Cam
2. Spacer (3/8 x 17/32 inch)
3.
Use tape or a marker to mark the exact locations
of the stop plates
Important:
If the stop plates are not aligned
correctly, the control handles could overload
the input shafts of the transmissions.
Figure 7
1. Bolt
4.
To access the mounting area for the cams,
remove the bolts that secure the stop plates to
the frame, and remove the stop plates
7).
Note:
Retain the stop plates and the bolts.
5.
Align the left-hand cam to the top hole in the
left-hand side of the frame, near the control
handle
(Figure
8).
3. Flange bushing
(Figure
7).
2. Stop plate
(Figure
g024658
1. Locknut (3/8 inch)
2. Fender washer (3/8 inch)
6.
Secure the cam with a 3/8 x 1-1/4 inch bolt, 2
fender washers, and a 3/8 inch locknut.
7.
Repeat steps
the machine.
4
Installing the Cam Brackets
Parts needed for this procedure:
4
Bolt (5/16 x 3/4 inch)
4
Flange nut (5/16 inch)
2
Cam spring
g023557
Procedure
1.
Align the mounting holes in the left-hand cam
bracket with the mounting holes in the frame,
near the installed cam
4
Figure 8
3. Bolt (3/8 x 1-1/4 inch)
4. Cam
5
and
6
for the right-hand side of
(Figure
9).
g024657
Advertisement
