Advertisement
Figure 12
Some parts shown as transparent
1. Cable (left-hand side shown)
Figure 13
1. Cable (left-hand side shown)
2.
Secure each cable to the frame by attaching a
cable tie through the hole in the frame near the
control-lever linkage on each side
Important:
Do not attach the cable tie to the
control-lever linkage.
g024664
1. Cable tie
2. Control-lever damper
3.
4.
g024683
(Figure
14).
1. Jam nut
2. Threaded fitting
3. Cable
6
Figure 14
Use a cable tie to secure each cable to the
control-lever damper on each side
Install each cable to the corresponding lift
bracket as follows
(Figure
A.
Slide the bellows away from the threaded
fitting.
B.
Remove the jam nut nearest the visible part
of the cable.
C.
Insert the threaded fitting into the opening
of the lift bracket.
Important:
Position the nuts so that
the threaded fitting is centered in the
bracket.
D.
Tighten the jam nut to secure the cable
assembly to the lift bracket.
E.
Install the bellows.
Figure 15
Left-hand side shown
g024654
3. Cable
4. Hole
(Figure
14).
15):
g024653
4. Cam bracket
5. Cable bellows
Advertisement
