Product Overview; Specifications; Attachments/Accessories; Operation - Toro 04651 Operator's Manual

Product Overview

Specifications

Model Number
04651
04653
04655

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
Weight
32 kg (71 lb)
34 kg (74 lb)
35 kg (77 lb)
6

Operation

Refer to your traction unit Operator's Manual for
detailed operation instructions. Before using the
cutting unit each day, adjust the bedknife; refer to
Adjusting the Bedknife-to-Reel Contact (page
Test the quality of cut by cutting a test swath before
using the cutting unit to ensure that the finished cut
is correct.

Adjusting the Cutting Unit

Adjusting the Bedknife-to-Reel
Contact
Adjusting the Bedknife Daily
Prior to mowing each day, or as required, verify proper
bedknife-to-reel contact. Perform this procedure
even though the quality of cut is acceptable.
1. Lower the cutting units onto a hard surface, shut
off the engine, and remove the ignition key.
2. Slowly rotate the reel in a reverse direction,
listening for reel-to-bedknife contact.
•
If no contact is evident, adjust the bedknife
as follows:
A. Turn the bedbar adjusting screws
clockwise
until you feel and hear light contact.
Note:
The bedbar adjusting screws
have detents corresponding to 0.018
mm (0.0007 inch) bedknife movement
for each indexed position.
1. Bedbar adjusting screw
2. Bedbar-adjusting-screw nut (2)
(Figure 4), 1 click at a time,
Figure 4
6).
g026076