Sealey AK2958 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment.
WARNING! Always wear approved eye or face protection when operating the torch.
‰
WARNING! Butane gas is extremely flammable, handle with care.
‰
WARNING! Always point the torch away from the eyes and body when igniting and during operation.
‰
WARNING! Ensure the Gas Controller Knob is firmly closed and the flame completely extinguished after use.
‰
WARNING! DO NOT puncture the cartridge or dispose of in a fire.
‰
DO NOT use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard.
8
Keep flammable material away from the torch when operating. Flammable waste, such as wiping or cleaning rags, must be placed in a
closed metal container and disposed of correctly.
DO NOT operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT hold the workpiece by hand. Use clamps or a vice (not included) to secure the workpiece.
8
DO NOT operate the torch if any parts are damaged or missing as this may cause failure and/or possible personal injury.
8
DO NOT touch the workpiece close to the heated area as it will be very hot. Allow to cool.
8
DO NOT touch the burner tube during or immediately after use as it will be very hot. Allow to cool.
8
DO NOT leave the torch operating unattended.
8
DO NOT use this torch continuously for longer than one hour.
8
DO NOT allow children to operate the torch.
8
Disconnect the gas cartridge when not in use. Store cartridge away from direct sunlight in a safe, dry, childproof area, where the
9
temperature will not exceed 40°C (104°F).
After use, allow the torch to cool before storing it.
9
IMPORTANT! Observe cautions on the gas cartridge label.
2. INTRODUCTION
Supplied with 3 interchangeable heads: Pin-point flame, Soft flame and Swirling flame, suitable for a range of soldering and
brazing jobs. Fitted with heavy duty piezoelectric ignition, safety lock and continuous flame switch. Precision heat control
with fine gas pressure adjustment. Suitable for CGA600 propane gas fuel types. Flame temperature: 1800ºC to 2200ºC. Cost
effective alternative to oxy/acetylene torches. Supplied in EVA storage tray.
3. CONTENTS
3.1. Three types of burner nozzle provided (fig.1)
fig.1
3
4
2
© Jack Sealey Limited
3-IN-1 INTERCHANGEABLE PROPANE TORCH
SET
MODEL NO:
Wear protective
Hot surfaces
gloves
Original Language Version
AK2958
No. Description
1 Main Body
2 Blast Flame(for brazing and large soldering.)
3 Pin point flame (for precision / small soldering
1
jobs.)
4 Large soft flame (for shrinking and heating jobs)
AK2958 Issue:1 04/10/22