Sealey AK2957 Quick Start Manual

thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. Safety
Warning! ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment.
Warning! Always wear approved eye or face protection when operating the torch.
‰
Warning! Butane gas is extremely flammable, handle with care.
‰
Warning! Always point the torch away from the eyes and body when igniting and during operation.
‰
Warning! ensure the Gas Controller Knob is firmly closed and the flame completely extinguished after use.
‰
Warning! Do not puncture the cartridge or dispose of in a fire.
‰
Do not use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard.
8
Keep flammable material away from the torch when operating. Flammable waste, such as wiping or cleaning rags, must be placed in a
closed metal container and disposed of correctly.
Do not operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
Do not hold the workpiece by hand. Use clamps or a vice (not included) to secure the workpiece.
8
Do not operate the torch if any parts are damaged or missing as this may cause failure and/or possible personal injury.
8
Do not touch the workpiece close to the heated area as it will be very hot. Allow to cool.
8
Do not touch the burner tube during or immediately after use as it will be very hot. Allow to cool.
8
Do not leave the torch operating unattended.
8
Do not use this torch continuously for longer than one hour.
8
Do not allow children to operate the torch.
8
disconnect the gas cartridge when not in use. Store cartridge away from direct sunlight in a safe, dry, childproof area, where the
9
temperature will not exceed 40°C (104°F).
After use, allow the torch to cool before storing it.
9
iMportant! observe cautions on the gas cartridge label.
2. introDuction
Impact resistant, contoured grip torch with stainless steel burner
nozzle for professional use. Anti-flare feature enables use of the
gun at any angle - even upside down. 1300°C Maximum flame
temperature. Piezoelectric ignition for ease of use. Accepts
standard Butane self-sealing cartridges (not included, order Model
no. SCS035)
3. Specification
Model no: ................................................................. AK2957
nett Weight: ................................................................0.32Kg
4. aSSeMBly
4.1. ensure that the control knob is turned off (fully clockwise)
before assembling.
4.2. Keep the gas cartridge upright when fitting to the torch.
4.3. Position the torch valve over the cartridge valve and
carefully screw the cartridge into the torch until it meets
the o-ring of the torch valve - take care to avoid cross-
threading.
Warning! Do not overtighten as this can damage the
‰
cartridge valve.
© Jack Sealey limited
Maxi Butane Heating torcH
Model no:
Wear protective Hot surfaces
gloves
Original Language Version
aK2957
Burner Tube
fig.1
Control Knob
Ignition Button
Gas Cartridge
AK2957 Issue 2 (HF) 21/02/19