Sealey AK2973 Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instruction protection
manual
1. SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this
‰
equipment.
WARNING! Always wear approved eye or face protection when operating the torch.
‰
WARNING! Butane gas is extremely flammable, handle with care.
‰
WARNING! Always point the torch away from the eyes and body when igniting and during operation.
‰
WARNING! Ensure the Gas Controller Knob is firmly closed and the flame completely extinguished after use.
‰
WARNING! DO NOT puncture or dispose of in a fire.
‰
DO NOT use the torch in an area where paint fumes, solvents or other flammable solids, liquids or gases pose a potential hazard.
8
Keep flammable material away from the torch when operating. Flammable waste, such as wiping or cleaning rags, must be placed in a
closed metal container and disposed of correctly.
DO NOT operate the torch when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
DO NOT hold the workpiece by hand. Use clamps or a vice (not included) to secure the workpiece.
8
DO NOT operate the torch if any parts are damaged or missing as this may cause failure and/or possible personal injury.
8
DO NOT touch the workpiece close to the heated area as it will be very hot. Allow to cool.
8
DO NOT touch the burner tube during or immediately after use as it will be very hot. Allow to cool.
8
DO NOT leave the torch operating unattended.
8
DO NOT use this torch continuously for long periods.
8
DO NOT allow children to operate the torch.
8
After use, allow the torch to cool before storing it.
9
IMPORTANT! Observe cautions on the gas filler cartridge label.
2. INTRODUCTION
Professional micro design featuring piezoelectric ignition. Fitted with automatic safety lock. Unit produces flame of up to 1300°C and will
operate for up to 45 minutes on a single fill. Features adjustable flame control and continuous flame function. Powered by Butane (lighter
fuel).
3. OPERATION
3.1. TO FILL (Refer to fig.1)
Use standard butane fuel. Fill in a well ventilated area away from open flame. Turn the torch off, make sure the flame is out, allow to cool
down for five minutes before filling.
3.1.1. Hold torch upside down and insert the filling can's nozzle into the gas filling valve. Press nozzle into the valve and release gas. Once gas
begins to seep out around the edge of the nozzle, the gas tank is full. Remove the filling can.
3.2. TO USE
3.2.1. Push slide switch down to unlock trigger.(fig1.1)
3.2.2. Depress button this starts gas flow and operates ignition.(fig.1.2)
3.2.3. Depress blue/black button to lock trigger for a continuous flame. (fig.2.1)
3.2.4. Move Gas Volume Control Lever to vary flame strength, Volume ranges
from 1 to 4. (fig.1.3)
© Jack Sealey Limited
MICRO BUTANE HEATING TORCH
MODEL NO:
Wear protective
Hot surfaces
gloves
Original Language Version
AK2973
1
3
AK 2973 Issue:1 07/10/22
fig.1