Canon DP-V2730 Operation Manual page 71

Sub Menu
Display Name
OSD Settings
Banner
Automatic Display
Picture Mode
Time Out
Function Button Guide
OSD Brightness
Protect Settings
Password
Protect Target
Picture Mode
Select Channel
Function Settings
Protect
Power Save
Sets the name of the main unit. You can input up to 16 alphanumeric characters.
Sets the banner display method for the channel name, signal information, and status of the video
display.
On, Off Automatically displays the banner when the input signal or picture mode
are changed.
On, Off Sets whether to display [Picture Mode].
On, Off The banner automatically disappears.
On, Off
[On]: When all OSD are hidden, you can display the list of functions
[Off]: Function Button Guide is not displayed.
Automatic Sets the brightness of the OSD.
(High - Middle)
Automatic The brightness is automatically adjusted to suit the luminance when
(High - Low) [Automatic] is selected. You can choose between [High - Low] and
High [High - Middle] adjustment ranges.
Middle
Low
Locks the settings so they cannot be changed. When you press the MENU button, [Signal/System
Information] appears, but other operations are grayed out because they are locked.
Set a password to protect settings. Use a four-digit number (0000 to
9999). The initial password is blank.
You can remove Picture Mode and Select Channel from the items to be
protected.
On, Off When set to [On], protects the [Picture Mode] settings.
On, Off When set to [On], protects the [Select Channel] settings.
On, Off When set to [On], protects the [Function Settings] and [Picture Function
Select [OK] to protect. When a password has been set, enter the
password and select [OK].
 Unlocking Protect Settings
Move the selection frame to [Protect] and press the Jog dial for
approximately 3 seconds. When a password has been set, enter the
password and select [OK].
120 min., 60 min., Automatically turns off video display's power supply when there is no
30 min., Off video signal input.
The message [No Signal, Turn off power by Power Save function.]
is displayed when there is no signal input for the selected time.
Approximately 5 minutes later, the message will read [No Signal, Turn off
power.] and the power will be turned off. The power is not automatically
turned off when this function is set to [Off].
Setting Options (Bold: factory default)
assigned to an F button on the video display by operating the jog dial.
Settings] settings.
OSD Menu
71