Operation - Toro 88710 Operator's Manual

Operation

Starting the Attachment
1. Ensure that the vents on the attachment, power
head, and battery are clear of any dust and
debris.
2. Align the cavity in the battery pack with the
tongue on the handle housing
3. Push the battery pack into the handle until the
battery locks into the latch.
4. To start the attachment, press the lockout button,
then squeeze the run trigger
Note:
Slide the 2-speed switch to change the
speed of the attachment.
1. Lockout button
2. 2-speed switch
(Figure 5).
Figure 5
(Figure 6).
Figure 6
3. Run trigger
Shutting Off the Edger
To shut off the edger, release the run trigger
Allow at least 5 seconds for the blade to stop moving.
Whenever you are not using the edger or are
transporting the edger to or from the work area,
remove the battery pack.
Removing the Battery Pack
from the Power Head
Press the battery latch on the machine to release the
battery pack and slide the battery pack out of the
machine (Figure
g357444
1. Battery latch
Removing the Attachment
from the Power Head
1. Ensure that the battery pack is removed from
the power head; refer to
Pack from the Power Head (page
2. Loosen the screw-handle on the shaft connector
(Figure 3).
3. Press the locking button down while pulling the
2 shafts apart
g357456
9
7).
Figure 7
Removing the Battery
(Figure 3).
(Figure 6).
g357457
9).