Adjusting The Depth Of Cut; Operating Tips - Toro 88710 Operator's Manual

Stick edger attachment
Hide thumbs Also See for 88710:
Table of Contents

Advertisement

Adjusting the Depth of Cut

1.
Remove the battery from the edger.
2.
Loosen the knob on the wheel and move it up or
down in the track to increase or decrease the
depth
(Figure
8).
1. Wheel knob
3.
Adjust the depth so that the blade barely touches
the ground when the machine is held in a normal
working position.
4.
Tighten the wheel knob.
5.
Standing in a normal working position, check the
depth of cut again and correct if necessary.
Figure 8

Operating Tips

Hold the edger with your right hand on the rear
handle and your left hand on the front handle.
Keep a firm grip with both hands while in operation.
The edger should be held at a comfortable position
with the rear handle at about hip height.
The edger will edge along sidewalks, driveways,
flower beds, curbs, and similar areas.
Cut at a steady pace. If the blade begins to slow
down, you are edging too fast; slow your pace. Do
not force the blade into the ground.
Light contact of the blade against the sidewalk
edge, curb, etc., is acceptable and will not damage
the edger.
To achieve the best appearance, edge when grass
is dry. Edging in wet soil or wet grass areas might
clog the blade guard and result in an uneven
edge. If the blade guard becomes clogged, stop
the edger, remove the battery and remove debris
g367405
from the blade guard.
1. Blade
10
Figure 9
2. Wheel
g333294

Advertisement

Table of Contents
loading

This manual is also suitable for:

323000001

Table of Contents