Before Starting To Use The Water/Ice; Dispenser - Blomberg BRFD2650SS5VFLR Operating Instructions Manual

Installation
3.13 Before starting to use the
water/ice dispenser
• If the water pressure is below 1 bar or a
demijohn will be used, than a separate must be
used as well.
• Water system of the refrigerator must be
connected to the cold water line. It must not
be connected to hot water line.
3
• No water may be obtained in the initial start-
4
up of the refrigerator. Because there is air in
the system. To discharge air from the system,
press dispenser latch for 1-2 minutes until
water comes from the dispenser. Water flow
may be irregular at the beginning. After the
air in the system is discharged, water flow will
return to normal.
• During initial use, you will have to wait
approximately 12 hours for the water to cool
down.
• It will take around 1-2 days for the system to
produce required amount of ice.
• Water pressure must be between 1-8 bars for
the operation of ice/water dispenser smoothly.
For this, check that 1 glass of water (100 cc)
can be filled in 10 seconds.
• The first 10 glasses of water should not be
consumed.
• You must wait approximately 12 hours to
obtain ice from the ice dispenser for the first
time. If there is not enough ice in the ice
container, ice may not be obtained from ice

dispenser.

• Do not consume the first 30 pieces (3-4 Litres)
of ice cubes.
• First several glasses of water may be turbid
when the filter is used for the first time.
Therefore, do not consume the first several
glasses of water.
• If the water dispenser is not used for a long
• If a power outage or a temporary failure occurs
• Ice cubes can stick to each other if they are left
• Water system installation of the refrigerator
A
• If the product is to be connected to the water
2
• Water system of the product is designed to
1
• It is recommended that the water is
• Do not attempt to dismantle the ice container
• Do not attempt to clean the ice container
• When taking water from the water dispenser,
14 / 32 EN
period of time, first 1-2 glasses of water can
be hot.
while the refrigerator is operating, ice can melt
down a little bit and then get frozen again. In
such a case, ice cubes can stick to each other.
If the outage or failure prolongs, ice can melt
down causing water leakage. If you experience
such a problem, empty and clean the ice
container.
in the container for a long time.
must be performed by the Authorised Service
Agent.
mains, make sure that you use potable water.
operate only with water. Do not use beverage
such as soft drinks and/or juices in the water
system.
disconnected if you will not be using the
refrigerator for a long period of time due to
vacation or similar reasons.
group assembly parts.
assembly without removing it from the
refrigerator.
remove the glass from the opening 1 second
after releasing the trigger. Thus, water in the
system will not drip into the drip tray.
Refrigerator / User Manual