Things To Do To Have The Filter Usage Time Calculated Automatically; Before Starting To Use The Water/Ice - Blomberg BRFD2652SS User Manual

Installation
3.11 Things to do to have
the filter usage time
calculated automatically
(in some models)
(For products connected to the mains water
line and equipped with filter)
1- Plug in the refrigerator. Press A (key lock)
button simultaneously to enable the key lock.
2- Then press on the following buttons in turn.
1. Vacation button
2. Fridge temperature setting button
4 3
3. Quick Cool setting button
4. Freezer temperature setting button
When the buttons are pressed in the correct order,
Key Lock symbol will turn off, buzzer will sound
shortly and Filter Change Warning indicator will
turn on. When the Filter Replacement Warning
button is pressed on, filter usage times are started
to be calculated automatically.
A
2 1
11 / 29 EN
C
If the filter usage time is calculated
automatically, Filter Change Warning
indicator will illuminate continuously in a
few seconds after the product is plugged
in.
C
Automatic filter usage time calculation is
not enabled ex factory. It must be enabled
in products equipped with a filter.
C
If the same procedure is repeated when
the automatic filter usage time calculation
is enabled, then the function will be
cancelled.
3.12 Before starting to use the
water/ice dispenser
• If the water pressure is below 1 bar or a
demijohn will be used, than a separate must be
used as well.
• Water system of the refrigerator must be
connected to the cold water line. It must not
be connected to hot water line.
• No water may be obtained in the initial start-
up of the refrigerator. Because there is air in
the system. To discharge air from the system,
press dispenser latch for 1-2 minutes until
water comes from the dispenser. Water flow
may be irregular at the beginning. After the
air in the system is discharged, water flow will
return to normal.
• During initial use, you will have to wait
approximately 12 hours for the water to cool
down.
• It will take around 1-2 days for the system to
produce required amount of ice.
• Water pressure must be between 1-8 bars for
the operation of ice/water dispenser smoothly.
For this, check that 1 glass of water (100 cc)
can be filled in 10 seconds.
• The first 10 glasses of water should not be
consumed.
Refrigerator / User Manual