Before Starting To Use The Water/Ice; Transportation Of The Product - Blomberg BRFD2230SS User Manual

Installation
3.11 Before starting to use the
water/ice dispenser
Water system of the refrigerator must be
connected to the cold water line. It must not
be connected to hot water line.
No water may be obtained in the initial start-
up of the refrigerator. Because there is air in
the system. To discharge air from the system,
press dispenser latch for 1-2 minutes until
water comes from the dispenser. Water flow
may be irregular at the beginning. After the
air in the system is discharged, water flow
will return to normal place container under
dispenser nozzle.
The first 10 glasses of water should not be
consumed.
During initial use, you will have to wait
approximately 12 hours to cool the water.
It will take around 1-2 days for the system to
produce required amount of ice.
If the water dispenser is not used for a long
period of time, first 1-2 glasses of water can
be hot.
If a power outage or a temporary failure occurs
while the refrigerator is operating, ice can melt
down a little bit and then get frozen again. In
such a case, ice cubes can stick to each other.
If the outage or failure prolongs, ice can melt
down causing water leakage. If you experience
such a problem, empty and clean the ice
container.
Ice cubes can stick to each other if they are
left in the container for a long time.
The water system installation of the
refrigerator must be performed by the
Authorized Service Agent.
If the product is to be connected to the water
mains, make sure that you use potable water.
Water system of the product is designed to
operate only with water. Do not use beverage
such as soft drinks and/or juices in the water
system.
It is recommended that the water is
disconnected if you will not be using the
refrigerator for a long period of time due to
vacation or similar reasons.
Do not attempt to dismantle the ice container
group assembly parts.
Do not attempt to clean the ice container
assembly without removing it from the
refrigerator.
When taking water from the water dispenser,
remove the glass from the opening 1 second
after releasing the trigger. Thus, water in the
system will not drip into the drip tray.

3.12 Transportation of the product

1. Unplug the product before transporting it.
2. Remove water connections.
3. Secure the shelves, accessories, crisper and
etc. in the refrigerator by adhesive tape before
repackaging it.
C
Packaging must be tied with thick tapes or
strong ropes and the rules of transportation
printed on the package must be followed.
C
Original packaging and foam materials
should be kept for future transportations.
A
WARNING:
are dangerous for the children. Keep
packaging materials in a safe place away
from reach of the children.
11 / 37 EN
Packaging materials
Refrigerator / User Manual