Cleaning The Fuel Strainer - Yamaha YT624 Owner's Manual

PERIODIC MAINTENANCE
7. Install the spark plug, and then tighten
the spark plug to the specified torque.
Tightening torque:
20 N·m (2.0 kgf·m, 15 lb·ft)
TIP
If a torque wrench is not available when in-
stalling a spark plug, a good estimate of the
correct torque is 1/4–1/2 turn past finger
tight. However, the spark plug should be
tightened to the specified torque as soon
as possible.
1. Fully tighten the spark plug using your fin-
gers.
2. 1/4–1/2 turn
8. Install the spark plug cap.
CLEANING THE FUEL
STRAINER
WARNING
Gasoline is a highly volatile and flam-
mable fuel. When handling gasoline, be
sure to observe the following points.
9 Do not smoke while carrying out a
service.
Also, never put any other open flames
close to the Snowblower while servic-
ing.
9 Before starting the service, discharge
any static electricity on yourself by
touching a metal chassis or other
metal object.
1. Stop the engine and remove the engine
switch key.
2. Turn the fuel cock lever to the "OFF" po-
sition.
3. Remove the ring nut, and then remove
the fuel strainer cup, the gasket and the
fuel strainer.
1. Fuel cock lever
2. Fuel cock
3. "ON"
4. "OFF"
5. Ring nut
6. Fuel strainer cup
– 49 –