Table of Contents
Advertisement
AT Commands
If the screen shows no characters, enter the E1 command to turn modem
echo on or enable local echo on the terminal.
Command
E
E1
* default
Online Character Echo F
In some lower speed modems the F command determines if characters
are echoed to the DTE from the modem when online. This function is
generally controlled by the communications software. The modem does
not support online character echo.
Hanging Up H, H1
To end a call, enter the H command. This tells the modem to disconnect
and go on hook. The modem must be in command mode to use this
command.
Enter the H1 command to take the modem off hook. The modem auto-
matically goes off hook when a dial command is keyed in.
Fast Disconnect H2, H3
The results of the H command can be modified by the H2 and H3
commands. H2 or H3 will not cause a hang up but will affect the
method of hanging up the next time the H command is issued. If H2 is
entered, the H command will hang up according to CCITT V.32 stan-
dards. If operating in V.32b mode the H2 command could take several
seconds. If H3 (the fast command) is entered, the H command will
hang up much more rapidly at those speeds.
Command
H
H1
H2
H3
* default
5-22
Echo off
Echo on *
The modem hangs up.
Forces modem off hook
Sets H command to normal hangup procedure (long
space, cleardown, protocol) *
Sets H command to fast hang up
Operation
Operation
V.3400
Advertisement
Table of Contents
