METPOINT
®
CID
12.3.4.2.9 Calibrating the touch panel
Settings -> Calibrate touchscreen
12.3.4.2.10 Display brightness
Settings -> Set backlight
42 | 56
If necessary, you can calibrate the touch panel on this screen.
Tap Calibrate. A calibration X will appear at the top left, then at the bottom
right, then at the bottom left, then at the top right and then in the centre.
Tap each of these X's as they appear.
If the calibration is completed successfully, the screen will show a message
saying "Calibration successful." Tap OK.
If it is not completed successfully, you can tap Cancel and then tap
Calibrate again to repeat the calibration process.
This screen can be used to directly adjust the display's backlight
(15 ... 100%).
For example: Backlight to 39%
You can enable the Backlight dimming after checkbox to make the backlight
be lowered to a minimum after a defined time interval (15 minutes in this
example).
As soon as the dimmed screen is used again, the backlight will
automatically return to the last brightness level set before dimming.
Original installation and operation manual