Saving A Measurement; Parameters For Measurement (Check) - Beko METPOINT CID Operation Manual

Original installation and operation manual

12.3.1.2 Saving a measurement

To save a measurement, either press the "Save" key on the membrane keypad (see section "Device components and
controls") or tap the "Store" button on the display.
All data will be stored on the internal SD card.
The measurement data, the measuring point and the measuring point image will be saved together as a leakage data.
They can then be exported and used with the BEKO Leak Management software to generate a report.
After pressing either the "Save" key or the "Store" button, you will need to complete the corresponding information
for the measuring point. The display will show the measuring point information for the last set of information that was
saved (company, building and place), and the LeakTag number will be incremented by 1.
For example:

12.3.1.3 Parameters for measurement (check)

Store -> Parameter
Store -> Meas. Point
At this point, make sure to check the "pressure" and "distance" parameters again if possible and correct them if
necessary. Changes to the parameters will result in new leakage and cost values.
For instructions on how to make corrections, see the description in section 12.3.1
METPOINT
If necessary, fill out the LeakTag
and affix it at the measuring
location.
Please use the correct LeakTag
number.
CID
®
27 | 56