Front Stabilizer Bar Installation; Ball Joint Service Preparation - Polaris RZR XP Turbo Service Manual

STEERING / SUSPENSION
4. Remove the fasteners
link to the stabilizer bar.

FRONT STABILIZER BAR INSTALLATION

r
1. Install the fasteners
to the stabilizer bar. Torque fasteners to specification.
TORQUE
Stabilizer Bar Link Fasteners:
40 ft-lb (54 Nm)
2. Install the stabilizer bar from the side.
3. Install the fasteners retaining the stabilizer bar mount
to the frame. Torque fasteners to specification.
TORQUE
Stabilizer Bar Mount Bracket Fasteners:
17 ft-lb (23 Nm)
q
4. Install the nut retaining the front stabilizer bar link
w
to the upper control arm
fasteners to specification.
8.14
r
retaining the stabilizer bar
retaining the stabilizer bar link
e
on both sides. Torque
TORQUE
Stabilizer Bar Link Fasteners:
40 ft-lb (54 Nm)

BALL JOINT SERVICE PREPARATION

Do not reuse a ball joint if it has been removed. If
removed, it must be replaced. Use this removal
procedure only when replacing the ball joint.
1. Properly lift and support the vehicle by the frame.
2. Remove the appropriate front wheel.
3. To service the upper ball joint: Remove and
discard the two front brake caliper mounting bolts
and remove the caliper from the brake disc (see
Chapter 9 – Caliper Removal , page
4. Remove and discard the upper ball joint pinch bolt.
5. If necessary, remove the lower front shock fastener
from the A-arm.
6. Remove the upper A-Arm to frame mounting bolts
and remove the A-arm from the chassis.
7. To service the lower ball joint: Remove and
discard the lower ball joint pinch bolt.
8. Remove both A-arm to frame mounting bolts and
remove the A-arm from the chassis.
9928491 R04 - 2017-2018 RZR XP Turbo / XP4 Turbo Service Manual
NOTE
).
© Copyright Polaris Industries Inc.