Starter One-Way Clutch Assembly - Polaris RZR 900 2015 Service Manual

ENGINE / COOLING SYSTEM
3. Remove the one-way clutch and inspect both sides
q
of drive rollers . Inspect the roller contact surface
w
inside the hub for wear, damage or uneven
surface.
4. Inspect drive surface of starter gear
r
for wear, damage or uneven surface. If any starter
one-way clutch component is worn or damaged,
replace the clutch and starter gear as an assembly.
9926814 R08 -
3.52

STARTER ONE-WAY CLUTCH ASSEMBLY

1. Install one-way clutch in clutch hub with flange of
clutch
2. Clean screw threads in flywheel to remove all oil or
e
and bushing
grease.
3. Place one-way clutch on flywheel and install the
three screws. Torque screws to specification.
4. Reassemble starter one-way clutch and gear using
the following illustration.
w
Pin
e
r
t
5. If starter gear was replaced, inspect the torque limit
gear.
2015-2016 RZR 900
q
engaged in recess.
TORQUE
One-Way Clutch Retaining Screws:
106 in-lbs (12 Nm)
y
Torque Limit Gear
u
Starter Gear
Asm
i
Screws
Asm
Bolt
© Copyright Polaris Industries Inc.
Flywheel
One-Way Clutch
Torque Limit Gear
2016 RZR S 1000 Service
Manual