Table of Contents
Advertisement
AIR-CONDITIONING & HEATING INSTALLATION - ASSEMBLY Continued
7. Cut a hole in the roof lining from inside the cab roof to
mount the hot water valve. Refer to Fig 58 (L).
8. Insert the plastic housing for temp switch (H) and snap in
position. Refer to Fig 57.
9. Cut two holes in the roof lining for the air con control panel
(I) and fit the control panel. Refer to Fig 57.
10. Screw on the valve and operating handle.
11. Connect the short length of heater hose (K), one end to the
heater unit (A) and one end to the hot water valve. Refer to
Fig 56 and 58.
12. Connect the two long heater hoses (M), one to the other
connection on the heater blower unit (A) and one to the
other connection on the hot water valve (L).
13. Slide the hose protection sleeves over both hoses.
14. Route both heater hoses with protective sleeves from the
rear corner post, through the rear right cab support posts
into the engine bay. Refer to Fig 59.
15. Lay the capillary pipe (J) from the temperature controller
(H) to the air conditioner and plug it in the existing hole
(about 50 mm). Refer to Fig 57 (H) and Fig 58 (J).
16. Bolt the air conditioning console to the rear of the cab with
the open side uppermost. This console contains the
condenser and dryer.
17. Slowly disconnect the climatic hose from the dryer.
18. Open the screw plugs slowly to allow the nitrogen to slowly
escape. The parts are filled with nitrogen to prevent
corrosion during storage.
19. Lead the hose from the condenser inward through the hole
in the rear strut of the cab.
20. Lay the hoses according to the picture and connect the thin
hose to the dryer again.
21. Lead the climatic hoses downward through the left hand cab
rear post.
Issued: 01.04.11
Approved:
Fig 57
Fig 58
Fig 59
Mod. No.
5060358
(H)
(J)
(K)
(L)
(M)
(N)
Sheet 49 of 64
Part No. 111-4431 (A)
(I)
Advertisement
Table of Contents
