Table of Contents
Advertisement
REAR DEFLECTOR - PARTS LIST
ITEM NO.
DESCRIPTION
1
DEFLECTOR ASSEMBLY - CAB KIT
2
NUT M5 NYLOC
3
WASHER PLAIN M5
4
SETSCREW M5*16
NOISE REDUCTION KIT - ASSEMBLY
Note: Before fitting any of the noise reduction components,
ensure that the sticking surfaces are free from dirt and
grease by using a suitable cleaner.
1. Inside the cab, fold the seat-back down to gain access to the
rear of the cab. Loosen the two M8 bolts holding the cab to
the platform and fit the plate (item 14). Refer to Fig 53.
Tighten bolts.
2. To fit components inside the cab, refer to Fig 53. Identify
items 10, 11, 12 and 13. Visually confirm locations and
verify proper fit before sticking. Remove backing from
components and fix into the locations. Refer to Fig 53.
3. Use a roller where possible to help adhesion.
4. Remove the retaining pins in the rear cab support brackets.
Carefully raise the cab/platform.
5. To fit components under the platform, refer to Fig 54.
Identify items 1 to 8. Visually confirm locations and verify
proper fit before sticking. Remove backing from
components and fix into the locations. Refer to Fig 54.
6. A roller should be used to press the components where
possible to help adhesion (as in step 3). Take special care
with making sure the edges are fully adhered. Full adhesion
takes up to 24 hours. Suitable additional adhesive should be
used where required.
7. Carefully lower cab/platform and ensure it closes correctly
and that all noise proofing material is away from moving
parts.
8. Replace the retaining pins in the rear cab support brackets to
secure platform.
Issued: 01.04.11
Approved:
PART NO.
111-0177
09430
09470
ZDH1E016U
Fig 53 - Internal cab positions
13
Fig 54 - Under platform positions
Mod. No.
5060358
QTY
ITEM NOTE
2
8
16
8
11
14
10
5
2
1
7
9
6
8
Sheet 47 of 64
Part No. 111-4431 (A)
12
3
4
Advertisement
Table of Contents
