Table of Contents
Advertisement
SAFETY CAB GENERAL ASSEMBLY - WIRING
29. Connect the red positive washer bottle wire to the red fuse
box positive battery feed. Refer to Fig 43.
Connect the red/black wire from the cab to the other side of
the fuse box.
Connect the brown negative wire tot he frame.
Connect the short red/black ignition wire assembly
connected to the other side of the fuse in the fuse box to
terminal 58 on the ignition switch.
Cable tie the cab wiring connections and the fuse box to
secure them safely in place.
30. Lower the cab/platform assembly.
31. Remove the two rearmost M8*30 setscrews (item 43) which
secure the fuel tank retaining brackets. Fit the LH and RH
cab support bracket assemblies with mounting plates (item
58) beneath the chassis mounting points using 4 M12*40
bolts, nuts and washers. Do not fully tighten at this stage.
Refer to Fig 44.
32. Lift the loosely bolted cab support 'U' bracket into position
and insert the retaining pins. Measure the free vertical
clearance in order to make an assessment of the number of
spacer plates and or thrust washers required for the final
assembly.
33. Replace the four M12*30 setscrews (removed at stage 33)
to secure the fuel tank retaining brackets and tighten
securely. Fully tighten all fasteners which secure the LH and
RH cab support bracket assemblies.
34. Seek assistance and replace the roof panel.
35. Replace the cab doors and fasten securely.
36. Fill the washer bottle.
37. Reconnect the battery terminals.
38. Replace the tool tray to protect the battery.
Issued: 01.04.11
Approved:
Fig 43
Fig 44
Mod. No.
5060358
Sheet 41 of 64
Part No. 111-4431 (A)
Advertisement
Table of Contents
