Ont Configuration File Over Omci - Nokia 7368 Product Manual

ONT configuration file over OMCI

ONT configuration file over OMCI
Table 8-2 Download configuration files (continued)
ONT type
MTK(eg.G240WF)
8.4 ONT configuration file over OMCI
WARNING
Equipment Damage
Executing the following procedure will trigger the ONT to reboot, which will impact ongoing
services.
Use this procedures to configure ONTs using configuration files via legacy method and OMCI.
8.4.1 Configuring an ONT using a configuration file via legacy method
1
Upload the ABCXXXXVER TAR file to the /ONT/ directory in the OLT.
A maximum of 250 files can be kept in the OLT file system.
2
Using OLT commands, download the TAR file to the ONT.
For OLT commands, refer to the 7360 ISAM FX CLI Command Guide for 100_320Gbps FD NT
and FX NT, or the 7342 ISAM FTTU Operation and Maintenance Using TL1 and CLI.
Please note:
• pri-cfgfile-pland/dnload or sec-cfgfile-pland/dnload can be 1 to 14 characters.
• pri-cfgfile-pland and pri-cfgfile-dnload should be the same name.
Examples
Note: X can be 1 or 2 unless specified:
a. If pland-cfgfileX= Disabled and dnload-cfgfileX= Disabled ,
no file will be downloaded to the ONT.
b. If pland-cfgfileX=FILENAME1 and dnload-cfgfileX= Disabled ,
FILENAME1 will be downloaded and FILENAME1 will be made active. An ONT reboot is
required.
c. If pland-cfgfileX=Disabled and dnload-cfgfileX= FILENAME2
FILENAME2 will be downloaded and FILENAME2 will be made passive. An ONT reboot is
not required.
d. If pland-cfgfileX=FILENAME3 and dnload-cfgfileX= FILENAME 4, the OLT reports an
error because the filenames are not the same.
174
Legacy method download
PRE file CFG file
✓
—
Nokia – Proprietary and Confidential
Use pursuant to applicable agreements
3FE-XXXXX-AAAA-TCZZA
7368 ISAM ONT
Zero management download
PRE file CFG file
✓ ✓
September 2020
Issue 1