Advertisement
captured in the lanyards on the drive pulley guard
(Figure 8).
18. Adjust the caster position and the blade height to
the correct height of cut referring to the Adjusting
the Height of Cut section in the Operator's Manual.
Install the deck cover and secure it with the removed
fasteners.
19. If the hydraulic pump by-pass valve was opened so
the power unit could be pushed, close the by-pass
valves, but do not over tighten. Check all fasteners
are correctly tightened and all fluid levels are at
the correct level. Start the engine referring to the
Starting and Stopping section in the Operator's Manual
and check the operation of all controls, referring to
the Operator's Manual.
20. Collect all parts and documentation back together for
the customer. Fill out the warranty and pre-delivery
inspection documentation.
Note: A warranty registration card needs to be
completed, both for the power unit and the deck.
2
Setting the Idle Speed
No Parts Required
Procedure
In order to ensure compliance with the EU Noise
Directive, the dealer is required to verify the correct
engine speed 2900 RPM when the power unit is
connected to models 02710 and 02711 and 3500 RPM
when the power unit is connected to model 02712.
2900/3500 RPM is the unloaded engine rpm, adjust
with the PTO Off (Disengaged). Tolerance is plus 0
rpm, minus 50 rpm. The engine should be warm; run
the engine for 15 minutes before adjusting. Double
check the final engine speed after settings are made and
tightened.
1. 1. Loosen the locknut and unscrew the high idle
screw a few turns. When setting the engine rpm on
power units connected to models 02710 and 02711,
replace the high idle screw with the high idle M5 x
50 screw supplied with 02710 and 02711 (Figure 9).
1
G018377
1. Speed control lever
2. Cable screw
2. Move the throttle lever, on the operator control
panel, to obtain the desired engine rpm.
3. Turn the high idle screw so that the end of it just
touches the speed control lever, and tighten the lock
nut (Figure 9).
4. Check the high idle speed and repeat this procedure
if necessary.
5. Loosen the cable screw and adjust the cable length
so that the throttle lever on the operator control
panel is set to full throttle when the speed control
lever touches the previously set high idle screw.
6. Tighten the cable screw.
4
2
3
4
Figure 9
3. Locknut
4. High idle screw
Advertisement
