Introduction; Contents - ABB Sace Emax 2 Installation, Operation And Maintenance Instructions For The Installer And The User

Introduction

1 - Contents

Overview This manual contains instructions on the operations to be performed on EMAX circuit-breakers E1.2
Integrated informations A full description of Emax 2 circuit-breakers is available in document
recipients This manual refers to two user profiles, as defined by standard IEC 60050:
Specifications and supporting
documents
Design notes The information in this manual was written in Italian and then translated into other languages to conform
4 | © 2022 ABB | 1SDH000999R0002 - ECN000232533
throughout their life cycle, from reception to installation, and from commissioning to subsequent
maintenance during operation, with particular attention to the environment at the end of the life cycle
of the product.
Reception Installation
Figure 1
engineering manual) available on the website ABB library.
IMPORTANT: all codes and documents mentioned in this document refer to Emax 2
configured with Trip unit Firmware version= 3.xx.
If the Firmware version of the Trip unit on the Emax 2 circuit-breaker =2.xx, consult
document 1SDH001330R0002
• Electrically Skilled Person (IEV 195-04-01): person with relevant education and experience to enable
him or her to perceive risks and to avoid hazards which electricity can create.
• Trained Persons in the electrical field (IEV 195-04-02): person adequately advised or supervised
by electrically skilled persons to enable him or her to perceive risks and to avoid danger which
electricity can create.
IMPORTANT: This manual specifically indicates what operations can be performed by
people trained in the field of electricity. All the remaining operations described in the
handbook must be performed by skilled persons, in the electrical field. ABB declines all
liability for damage to persons or property caused by failure to comply with the instructions
in this document.
To ensure that the Emax 2 circuit-breaker is installed and configured correctly, please read the information
in this manual and in the technical documentation of the product, supplied with the circuit-breaker or
available in the website ABB
Document
1SDH001330R1002
1SDH001316R1002
1SDC200023D0906
1SDM000091R0001
1SDH001140R0001
to the laws and/or commercial requirements concerning the product.
Commissioning
available on the website ABB library.
liBRARy
Description
Manual for design engineers with full information about the trip units
and accessories for Emax 2
Manual of Ekip Touch trip units for Emax 2 circuit-breakers
Sace Emax 2 CBs General catalog
Sace Emax 2 CBs Circuit diagrams
Communication System Interface for Emax 2 CBs
ABB | SACE Emax 2
Maintenance Disposal
1SDH001330R1002
Introduction | 1 - Contents
(Emax 2