Setup And Preparation Before Operation; Pre-Operation Procedure; Precautions When Handling - Mitsubishi Electric AJ65VBTCU-68DAVN User Manual

4 SETUP AND PREPARATION BEFORE OPERATION

4 SETUP AND PREPARATION BEFORE OPERATION

4.1 Pre-Operation Procedure

4

4.2 Precautions When Handling

CAUTION
4 - 1
This section explains the preparatory procedure for operating the AJ65VBTCU-
68DAVN.
START
Mode select switch setting
Create a program.
(refer to Section 4.3, Section 4.4)
Create a program. (Refer to Chapter 5.)
Create a program.
Make offset/gain setting?
Yes
Offset/gain setting (Refer to Section 4.5.)
END
The precautions when handling the AJ65VBTCU-68DAVN are described below:
Do not touch any terminal while power is on. Doing so may cause malfunction.
Prevent foreign matter such as dust or wire chips from entering the module.
Such foreign matter can cause a fire, failure, or malfunction.
Do not disassemble or modify the modules.
Doing so may cause failure, malfunction, injury, or a fire.
Do not directly touch any conductive part of the module.
Doing so can cause malfunction or failure of the module.
Do not drop or apply strong shock to the module.
Doing so may damage the module.
Tighten the terminal screw within the specified torque range.
Undertightening can cause short circuit or malfunction.
Overtightening can damage the screw and/or module, resulting in drop, short circuit,
or malfunction.
No
Start data link.
MELSEC-A
4 - 1