Tensioning The Drive Belt - Siemens SIREMOBIL Iso-C Service Instructions Manual

Brakes / Movements
Fig. 9

Tensioning the drive belt

WARNING
WARNING
•
Move the C-arm to the middle orbital position.
•
Remove the C-arm counterbalance weight on one side of the C-arm.
•
Slacken the drive belt (1/Fig. 9).
•
Loosen the holder of the drive belt (1/Fig. 10).
•
Adjust the drive belt in the holder by one tooth to tension it. Then fasten it again.
•
Reattach the holder of the drive belt.
•
Tension the drive belt (1/Fig. 9).
•
Reinstall the C-arm counterbalance weight.
•
Repeat the procedure at the other end of the C-arm.
Siemens AG
Medical Solutions
1
Risk of injuries on mechanical parts!
If not observed, slight to medium injuries, especially to the hands,
can occur.
Observe the notes concerning the C-arm carbon fiber structure.
Risk of injury!
Noncompliance can lead to medium to severe injuries and/or
property damage.
The C-arm covers contain counterbalance weights and weigh
approx. 6 kg.
Hold the covers firmly when installing or removing them.
Before the C-arm cover will be loosened, the C-arm must be
moved to its middle orbital position.
If the C-arm covers are loosened, the C-arm may not be moved to
its orbital end positions (I.I. or SIREPHOS at the orbital end posi-
tion).
SPR2-230.061.01
Rev. 13
Fig. 10
Page 9 of 10
12.04 CS PS 24
7 - 9
1
SIREMOBIL Iso-C
System Manual
7