Tensioning The Drive Belt - Siemens SIREMOBIL Iso-C Troubleshooting Manual

Brakes / Movements

Tensioning the drive belt

Fig. 60:
WARNING
WARNING
Move the C-arm to the middle orbital position.
Remove the C-arm counterbalance weight on one side of the C-arm.
Slacken the drive belt
Loosen the drive belt holder
Adjust the drive belt in the holder by one tooth to tension it. Then fasten it again.
Reattach the drive belt holder.
Tension the drive belt
Reinstall the C-arm counterbalance weight.
© Siemens, 2008
For internal use only
Risk of injury on mechanical parts!
If these guidelines are not followed, minor to moderate injury,
especially to the hands, can occur.
Follow the notes concerning the C-arm carbon fiber
structure.
Risk of injury!
Noncompliance can lead to medium to severe injuries and/or
property damage.
The C-arm covers contain counterbalance weights and
weigh approx. 6 kg.
Hold the covers firmly when installing or removing
them. Before the C-arm cover is loosened, the C-arm
must be moved to its middle orbital position. If the
C-arm covers are loosened, the C-arm may not be
moved to its orbital end positions (I.I. or SIREPHOS at
the orbital end position).
((1/Fig. 60 / p. 145)).
((1/Fig. 61 / p.
((1/Fig. 60 / p. 145)).
SPR2-230.840.01.01.02
08.08
Fig. 61:
145)).
Page 145 of 148
CS PS SP
145
7.7
SIREMOBIL Iso-C