Toshiba STRATA DK24 Manual page 437

PROGRAMMINGPROCEDURES-INSTRUCTIONWSYSTEMRECORDS
SECTION 200-096-302
FEBRUARY1991
LCRCOLINEPROGRAMING
1) Use Program 16 to assign CO lines in groups per the reference chart below.
CO Line Group Reference Chart
Line Group
1
(81)
2 (82)
3 (33)
4 034)
5 (85)
6 (86)
7
107\
CO Lines in
Group (1 - 36)
CO Line Type/Comments
2)
Use Program 40 to allow CO lines access to stations using LCR for outgoing calls.
3) Use Program 41 to deny outgoing CO line access except for LCR access.
Important: Area code and office code structure must be defined by Program 45-l
(Toll Restriction Dial Plan) for LCR to work properly.
4) Use Program 45-1 to enable the dial plan that is appropriate for the area where LCR calls will originate.
PROGRAM50-1
LCRPARAMETERS
SELECT = 1
Press Key LEDs for each LCR parameter.
LED Key X
LED On LED Off
1
Enable System LCR No LCR
2
Not Used
Not Used
3
555 LDI Route Per Program 50-4 Per Area Code Table
4
Dial Tone After LCR Access Silent
5
Warning Tone Last Choice Route No. No Warning Tone
NOTES:
7. For more information, see the instructions preceding the record sheets.
2. Program 40 denies CO line access via LCR and denies all other access methods.
3. Program 41 allows CO line access via LCR but denies all other outgoing access methods:
(701-736, 81-88, CO key).
4. initialized data: All LEDs OFF.
2-138