Mitsubishi Electric AE630-SW Instruction Manual page 13

●(B) Terminals
1)
Name Description
C1, C2 3) Output terminals for SHT
3)
A1, A2 Output terminals for CC
3)
U1, U2 Output terminals for MD
K12 Digital input1 terminal
K22 Digital input2 terminal
K32 Digital input3 terminal
K11 Input common
■1): Terminal assignment is shown in
■2): These terminals should be connected with wire using crimp-type terminal.
The available crimp-type terminal is shown in figure 3.10.
■3): These output terminals are exclusive to SHT/CC/MD.
■4): About the remote control via the CC-Link network, or local control with
pushbuttons, the sample of user's wiring with BIF-CON and AE-SW is
shown in figure 3.11.
1)
These cables and switches
are required if digital input
functions are used.
(*not attached to BIF-CON)
■1): The switch that can
open and close the
minute load (12V, 30mA)
should be use.
2)
Screw
(Tighten torque)
M3
(0.5 to 0.6N.m)
"7. Outline dimensions"
.
Fig 3.11: Sample of user's wiring
E-13
max. 6mm
Fig 3.10: Crimp-type terminal
1)
Pushbuttons are required only if SHT/CC/MD are
2)
driven by local operation .
■1): Pushbuttons are not attached to BIF-CON.
Therefore, these should be prepared by the user.
■2): In case of local operation by pushbuttons,
REMOTE/LOCAL switch placed on the BIF-CON
should be in LOCAL position for safety.
"(C) REMOTE/LOCAL switch"
(see also
1)
These connection cables are required if SHT/CC/MD
are driven by remote control 2)
■1): These cables are not attached to BIF-CON.
Therefore, these should be prepared by the user.
■2): In case of remote control, REMOTE/LOCAL switch
placed on the BIF-CON should be in REMOTE
position. (see also "(C) REMOTE/LOCAL switch"
SHT and CC cannot be
driven simultaneously.
).
.
).