Configuring The Ip Address With Window Xp - Mitsubishi Electric Netcom 2 User Manual

2. Open a HyperTerminal session by selecting (Installed location may vary)
Start > All Programs > Accessories > Communications > HyperTerminal.
3. Select an available communications port from the drop-down list.
4. Select the following port settings:
  B its per second: 19200
  D ata bits: 8
  P arity: None
  S top bits: 1
  F low Control: None
5. Cycle power from the Netcom by pulling out the power connector and
reinserting.
6. Wait for > and type test, this must be done within five seconds. This will
disable the time out function and allow the IP address to be changed.
7. Type setup and enter.
8. The default IP address, IP mask, and IP gateway will be displayed.
9. Enter your IP address and press enter.
10. Enter your sub net mask and press enter.
11. Enter your IP gateway and press enter.
12. After the IP gateway is entered it will ask to save the changes, enter y.
13. When connecting to a 9700 or 2033A the protocol must be change, this is
accomplished by typing "ups m". After entering ups m the user will see
"Mitsubishi protocol selected", the user must type in "commit" to save the
change.
14. System will now reboot and is ready for Internet connectivity.
4.2.2 Configuring the IP address with Window XP.
1. Connect the cross over cable provided with the Netcom2 to your PC and the
"Network" RJ45 port of the Netcom2.
2. Plug in the power supply included in the Netcom2 box to the +12VDC.
SVA026 Netcom 2 User Manual ver5 8