Mitsubishi Electric Netcom 2 User Manual page 16

19. The user will be able to change the IP information from this screen. After the IP
information has been entered the "Save" button must be selected for the
information to be saved.
20. Once the "Save" button is selected you will be presented with the following
screen. Selecting OK will write the IP address to the memory of the Netcom. You
will no longer be able to communicate with the Netcom at the default IP address.
21. If the Netcom2 is going to be connected to a 2033A or 9700 the protocol will
have to be changed using the DB9 connector supplied with the Netcom2. Please
refer to the step XX.
SVA026 Netcom 2 User Manual ver5 16